Free Shipping on Orders Over $135
Using GluBoost Fill n Finish as a complete finish on faceplate turnings, like bowls, plates, and turned boxes or vessels.
After your final sanding, apply Fill n Finish Thin either directly to the wood or to an application pad, and spread it evenly while the lathe is running at its slowest speed. When it’s smooth, cure it with two light sprays of GluDry. If you want a thicker finish, or a buffed gloss finish, apply a second (or third) coat the same way, again curing it with GluDry. Once the finish is to your liking, you can buff it to gloss by sanding through the grits to ultra-fine paper, then buffing with a pad loaded with rubbing or polishing compound.
Sometimes when you are designing a piece of furniture, a door or a wall panel, you will often need accent pieces to add a bit...
Read More →
One great use of Fill n’ Finish is to build up a clear finish on raw wood. Without using any of the typical film coat...
Read More →
GluBoost Fill n’ Finish makes a great finish on many projects. (Body) For some woodworkers, applying a finish is that tedious task that you...
Read More →
The frustrating job of filling a finish flaw, drop filling, is made so much easier using Fill N’ Finish. It is a life saver! ...
Read More →
EndPoint and MasterShield Masking
Fingerboard Inlays With Fill n' Finish
Ding Repair With Fill n' Finish
