By submitting this form, you are consenting to receive marketing emails from: . You can revoke your consent to receive emails at any time by using the SafeUnsubscribe® link, found at the bottom of every email. Emails are serviced by Constant Contact
Finishing spindles or other between center turnings right on the lathe using GluBoost Fill n Finish.
Once the piece is sanded smooth, apply Fill n Finish Thin either directly to the wood or onto an application pad either with the wood still, or while the lathe is running at its slowest speed. Spread the Fill n Finish until it is very smooth, then cure it with two light sprays of GluDry.
Want a thicker or glossier finish? Repeat the same process for a second (or third) coat. Once it is sprayed and cured, you can buff it to high gloss by sanding up through ultra-fine papers, then buffing with rubbing or polishing compound.
There are numerous opaque pore fillers, and a handful of clear ones as well, but none work quite so fast as GluBoost Fill...
Read More → Prepare Surface – Use Fill n’ Finish and GluBoost GluDry for pore filling and as primer sealers. Adjust nozzle tip to pattern of...
Read More →Let’s discuss some tips on using GluBoost MasterGlu, Endpoint Mark + Mask vinyl tape, and MasterShield tape to repair a guitar nut. Nut...
Read More →Let’s talk about some tips on here with tips on using GluBoost MasterGel Ultra, GluDry, and Fill n Finish to create beautiful custom inlaid...
Read More →